Alert Program
Setup Assistant
Setup Assistant
How To Put Your Detector Back In Setup Mode
This process is required so that you can connect your detector to your home Wi-Fi network. To be able to connect, you need to put your detector back in setup mode.
-
Open your detector battery compartment.
-
Remove the batteries and then put them back.
-
You should hear a bip and your detector will start blinking greenn. This means your detector is in setup mode.
-
Put the battery cover back. You are ready to setup your detector. Go back to the Alert section of the app and launch “Add a detector” again.
Is your detector in setup mode?
No, it emitted 2 beeps and does not blink green
No, it did not beep and does not blink green